REFERENCE 04 // SYSTEM SPEC STATUS: UNCOMPRESSED / LOSSLESS

SIGNAL RESOLUTION & SPECS.

Precise architecture documentation for hardware patch bays, stereo bus calibration, master output headroom, and high-impedance routing limits.

RATE: 192 kHz / 32-bit Float

DYNAMIC RANGE: 131 dB A-Weighted

BUS LATENCY: < 0.4 ms

PATCH POINT ATTENUATION // 10K OHM INPUT LOAD DISCRETE OP-AMP OVERDRIVE HEADROOM // +28 dBu PEAK CLOCK DRIFT: ±0.1 PPM TCXO STABILITY BALANCED XLR / TRS COMPLIANT IMPEDANCE MATRIX

INDEXED DIRECTORY

OPERATIONAL INQUIRIES

Direct engineer replies regarding hardware tolerance, master channel wiring, and frequency phase response.

What electrical tolerance is allowed on the analog CV inputs without clipping?

The analog control voltage (CV) stage accepts a true bipolar range of -10V to +10V. Any over-voltage exceeding +12.4V engages the passive Schottky clipping diode array, shunting excess current straight to earth ground before it encounters the precision summing bus. Pitch tracking stays strictly within 1 cent across 7 octaves under this window.

Does the internal routing engine color the signal when running pure unmixed direct outs?

No. The direct outs bypass all master transformer saturation coils and operational amplifier summing nodes entirely via physical gold-contact relay switches. When running dedicated channels, your total harmonic distortion (THD+N) measures below 0.0003% from 10 Hz all the way up to 48 kHz.

Can balanced and unbalanced equipment be patched into the master bay simultaneously?

Yes. Every port employs an impedance-sensing differential detection loop. Connecting a standard TS mono cable to a balanced TRS input automatically grounds the cold ring line without a 6 dB drop or inductive hum, keeping stage gains normalized across your entire hardware rack.

How does the unit handle word-clock drift when slaved to external master studio clocks?

The BNC sync port feeds an onboard temperature-compensated crystal oscillator (TCXO) with continuous phase-locked loop (PLL) re-jitter filtering. Incoming signal jitter above 3 picoseconds is discarded at the digital receiver, eliminating inter-sample modulation pops and conversion clicks.

What are the grounding recommendations for eliminating ground loops across guitar preamps?

All high-impedance instrument inputs feature an isolated galvanic earth switch on the rear panel. When connecting high-gain instrument circuits alongside line-level outboard gear, toggle the ISO GROUND switch to position LIFT to sever common chassis pin-1 return paths while maintaining full RFI shielding.

Is calibration required when switching acoustic monitor rooms or changing output leads?

Factory calibration holds true for 12,000 continuous operating hours. However, if cable runs exceed 30 meters, we suggest running the built-in pink noise phase verification sweep from the utility menu to calculate any cable capacitance high-frequency rolloff above 22 kHz.